0

1.

1.1 Applicable Industries

Widely used in screen‑printing stencil making for consumer electronics, phone lens & glass cover plates, light guide plates, PCB, LCD, automotive electronics, household glass, apparel & footwear printing. Suitable for reinforcing stencils with water‑based and dual‑purpose water‑solvent photoresist emulsions.

1.2 Product Features

Two‑component stencil hardener, mix Component A and Component B at ratio 1:1 before use. After mixing, it triggers cross‑linking reaction with photosensitive emulsion and forms a dense protective layer on emulsion surface. It greatly improves stencil water resistance, abrasion resistance and solvent resistance. Printing cycles can be increased by 3‑5 times, reducing screen replacement frequency and production cost.
Easy application by sponge or soft cloth for both sides of stencil. Low‑odor, heavy‑metal‑free and eco‑friendly. Fast hardening reaction with good ink permeability after treatment.
Note: Stencils treated by this hardener cannot be reclaimed. Not recommended for nylon or stainless steel mesh.

1.3 Main Technical Specifications

表格
ItemSpecificationItemSpecification
Product FormTransparent liquid for both A & BMixing RatioA : B =1:1 (by weight / volume)
Packaging1L+1L per set; 5L+5L per setCompatible EmulsionWater‑based & water‑solvent dual‑purpose emulsion
Shelf‑life2 years in un‑opened sealed conditionOperating Temp.20‑30℃, optimal at 25℃
Ambient Humidity45‑55%Curing Oven Temp.40‑60℃
Treated stencil features excellent wear‑proof, water‑proof and solvent‑proof performance with smooth surface, free of pinholes or wrinkle defects.

1.4 Environmental Requirement

Storage: Keep tightly sealed in cool & dark place at 5‑25℃. Avoid high‑temperature and direct sunlight. Working environment: temperature 20‑30℃ (optimum 25℃); relative humidity 45‑55%. ⚠️ Mixed working solution shall be consumed promptly, long‑term storage is prohibited.

Operating Instructions

  1. Complete stencil secondary exposure, developing and thorough drying.
  2. Mix Component A and B thoroughly at 1:1 ratio.
  3. Apply mixed hardener evenly onto both squeegee‑side and print‑side of stencil with sponge or soft cloth, avoid heavy dripping.
  4. Leave for approx. 1 minute to allow full penetration. Blow off or blot excess hardener from stencil surface by air gun or clean cloth. Residual hardener will block mesh openings and damage ink flow.
  5. Cure stencil in oven at 40‑60℃ for minimum 30‑60 minutes. Insufficient curing will weaken hardening effect. Rinse cooled screen gently with clean water and dry completely before printing.

Safety Precautions

This product is weakly acidic.
  • Wear protective gloves and goggles during handling; ensure adequate ventilation.
  • Skin contact: Remove contaminated clothing, rinse skin thoroughly with plenty of soapy running water.
  • Eye contact: Remove contact lenses. Flush eyes continuously with abundant clean water for at least 15 minutes. Seek medical assistance if irritation persists.
  • Ingestion: Rinse mouth. Do NOT induce vomiting. Seek medical help immediately.
  • No eating, drinking or smoking while handling product.

1.5 Spare & Wear‑parts List

No mechanical wearing parts for chemical consumable.
Reminder: Tighten cap immediately after opening.

1.6 Main Material Information

表格
Material NameRemarks
Hardener Component AOriginal TDScreen
Hardener Component BOriginal TDScreen